Snapper RTX102 Manual Do Utilizador página 104

PROBLEM
Damaged mowing deck drive belt
The drive belt is insufficiently tensioned
Inappropriate mowing height
THE MOWING DECK
A foreign object is preventing the
DRIVE BELT STOPS
movement of the belt
DURING OPERATION
Damaged belt pulleys
Worn out parts of the tensioning
mechanism
The grass is too high or wet
THE MOWING DECK
DRIVE BELT IS The drive belt is insufficiently tensioned
SLIPPING THROUGH
Worn out or damaged mowing deck
belt tensioning spring
A foreign object is preventing the
movement of the belt
THE MOWING DECK
DRIVE BELT IS BEING
Damaged belt pulleys
EXCESSIVELY WORN
Inappropriate mowing height
OUT
The drive belt is insufficiently tensioned
Damaged or worn out blade drive belt
Damaged spring of the tensioning
THE BLADES CANNOT
mechanism
BE PUT INTO MOTION
A foreign object is preventing the
movement of the belt
The drive belt is insufficiently tensioned
THE BLADES STOP
A foreign object is preventing the
WITH A DELAY
movement of the belt
Incorrectly functioning electromagnetic
clutch
MOWING DECK PROBLEMS (continued)
POSSIBLE CAUSES
104
REMEDY
► Check the condition of the belt pulleys. Perhaps the
belt jumped out of the belt pulley or it was damaged.
Replace it if necessary.
► Check the tension of the drive belt (
and tension it if necessary. Also check the route of the
belt.
► Check the set mowing height, adjust if necessary.
► Check the movement of the belt and remove all foreign
objects or dirt if necessary.
► Recheck all the belt pulleys. Buckled or cracked belt
pulleys may cause problems. Replace if necessary.
Also check the inside surface of the pulley on the
engine. If it is coarse or has cracks, it is necessary to
replace the pulley.
► heck the parts of the tensioning mechanism for wear
and replace if necessary.
► If the grass is too tall or wet, the mowing deck drive
belt may slip through. Check that the belt is not worn
out. If it is, replace it.
► Check the tension of the drive belt (
and tension it if necessary.
► Check the spring of the mowing deck belt tensioning
mechanism. Replace the spring if it is overstretched or
damaged.
► Check all the points along the route of the belt. Check
whether the movement of the belt is not prevented by
a foreign object. If yes, remove the foreign object.
► Check the pulleys, if they are damaged, replace them.
► Check the set mowing height, adjust if necessary.
► Check the tension of the drive belt (
and tension it if necessary.
► Check the condition of the belt - replace it if necessary.
If it is loose, tension it.
► Check the condition of the spring of the tensioning
mechanism and replace if necessary.
► Check whether the movement of the belt is not
prevented by a foreign object. If yes, remove the
foreign object.
► Check the tension of the drive belt (
and tension it if necessary. If the belt cannot be
tensioned due to its considerable wear, replace the
belt.
► Check whether the movement of the belt is not
prevented by a foreign object. If yes, remove the
foreign object.
► Check that the electromagnetic clutch switches off
properly. If the clutch is not working properly have it
replaced or repaired at an authorised service centre.
6.3.8 and 6.3.9)
6.3.8 and 6.3.9)
6.3.8 and 6.3.9)
6.3.8 and 6.3.9)