Snapper RTX102 Manual Do Utilizador página 78

► Tilt the grass catcher by 90° and from the bottom side screw on the lower braces. Attach one side of the braces to
the front tube and the second side to the rear tube. For the 320 l grass catcher use two braces, for the 380 l grass
3.6.2f
catcher use three braces.
► Pull the rubber edges of the sack over the front tube.
3.6.2g
► From above, put the top handle against the lid and screw it in from the underside using two bolts with washers,
inserted from the underside into the grooves of the lid braces.
3.6.2h
► Insert the dump lever handle into the hole in the grass catcher lid.
► Into the holes in the bottom end of the lever, screw in a bolt from the outside.
3.6.2i
► Screw the grass catcher hinges (1) on to the rear plate. For this purpose use the installation markings on the plate
indicating the correct position of the hitches.
3.6.2j
► Only screw on the lower hitch (2) if you will be using a trailer (optional equipment).
ADJUSTMENT OF THE GRASS CATCHER POSITION AFTER INSTALLATION
► Hang the grass catcher on the hitches (1) on the rear plate of the mower.
► Check that the grass catcher and the mudguards match up. The arrow tips stamped on the lid of the grass catcher
and the mower's fairing must point to each other while the distance between the grass catcher and the grass
3.6.2k
catcher plate must be no greater than 3 mm.
► If the grass catcher does not align, it means that the hitches (1) are not in the correct position.
► Remove the grass catcher and adjust the position of the hitches relative to the direction that it did not align with the
mower:
- loosen bolts (A) to move the hitches up and down
- loosen bolts (B) to move the hitches forwards and backwards
3.6.2l
► After adjusting the position, tighten the bolts and again hang the grass catcher and check that it is in the correct
position.
► Also check the position of the contact spring of the full grass catcher sensor (10) – the spring must be touching the
switch (C), otherwise the mowing deck will not function.
3.7 CHECKS PRIOR TO STARTING UP
3.7.1 CHECKING THE MOTOR OIL
► Position the mower on a horizontal surface.
► Open the hood and find the oil dipstick. Depending on the type of engine, the dipstick is either on the left or on the
right side. In the event that you are unsure, please consult the included engine manufacturer's manual.
► Screw out the oil dipstick, wipe it clean using a dry cloth, reinsert it and screw it in. Then again screw it out and
3.7.1
check the oil level. The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so
that it reaches the top mark.
A more detailed description including the type of oil can be found in the user's manual of the engine's manufacturer.
3.7.2 CHECKING THE BATTERY
Check the battery charge level according to the user's manual of the battery. Respect all the manufacturer's instructions especially
when checking and charging the battery.
78