Snapper RTX102 Manual Do Utilizador página 76

DISPOSAL OF PACKAGING MATERIALS
After unpacking everything, ensure that the packaging material is properly disposed of. The disposal must conform to relevant
waste disposal laws valid in your country.
In the event that you are unsure about the disposal procedure, have this performed by a specialised company.
3.5 MOWER DOCUMENTATION
The mower is supplied with the following documentation:
- Packaging note
- User's manual
- User's manual for the engine
- User's manual for the battery
- Customer contact guide
3.6 ASSEMBLY OF THE SEPARATELY PACKED ASSEMBLIES
Due to the technical nature of this task, the mower is prepared for operation by the vendor of your riding mower (according to the
following instructions).
Before starting the installation, remove all covering protective materials, locate the riding mower on an even surface and align the
front wheels to face forward.
3.6.1 SEAT, STEERING WHEEL AND BATTERY
a) Mount the plate on the underside of the seat:
► Screw the attachment plate (1) to the underside of the seat. For this purpose, use four collar nuts (M8×25).
3.6.1a
b) Attach the seat to the tilting console:
► Tilt out the seat console (2) by approximately 90° upwards.
► Into the hole in the left and right washer (3) insert a total of 4 bolts (M8×25) and place both washers on the
3.6.1b
grooves of the console. From the other side, put on the seat with the plate and bolt it to the console. Tighten the
bolts only lightly, the seat must remain mobile at this time.
c) Install the seat sliding mechanism and attach the safety switch:
► Place the seat positioning mechanism (5) against the plate console (4) and attach it using two bolts.
► Adjust the position of the seat and tighten all loosely tightened bolts.
► Tilt the seat together with the console down to the working position and using the sliding mechanism lever, set
3.6.1c
the appropriate seat position for your body size.
► In the event that the safety switch (6) was removed from the seat prior to transport, slide it into the hole on the
underside of the mower and connect the electric cable (7) to it.
d) Install the steering wheel:
► Steering wheel rod (1) has two holes enabling the steering wheel to be set to two heights. Select the hole based
on your body dimensions and individual preferences, put the steering wheel on to the rod and turn it so that
the hole (2) in the steering wheel overlaps the selected hole in the rod. Then insert the pin (3) into the hole and
knock it in using a hammer.
3.6.1d
► If necessary, adjust the angle of the steering wheel using the clamping levers (4). Release the lever by pulling
it towards yourself, set the steering wheel to the desired position and then lock in the lever by pushing it away
from yourself.
If your mower is equipped with a seat with armrests, install the armrests according to the user's manual of the seat manufacturer.
The manual is supplied together with the other documentation that came with the mower.
e) Connect the battery:
► Remove the cover beneath the steering wheel. The battery is located in the area behind the cover.
► Loosen the bolts on the pole terminals of the battery.
3.6.1e
► Place the red wire on the (+) pole of the battery and secure in place with the bolt.
► Place the brown wire on the (-) pole of the battery and secure in place with the bolt.
When connecting a battery, it is always necessary to first connect the positive cable (+).
The location of the terminals may differ based on the battery's manufacturer, therefore always first check which side the terminal is
located on.
When putting the battery into operation, proceed according to the instructions provided in the included user's manual of the battery.
Adhere to all safety instructions provided by the manufacturer.
76