Descargar Imprimir esta página

COMPANION 27826 Manual De Las Instrucciones página 22

Publicidad

2
O
To install bagger components
to tractor
1.
Discharge
Chute
2.
3/8 Nut
/
_
3.
Flat Washer
3"
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
4
1. Support Bracket
2.
Clevis Pin 10x 17mm
3.
Retainer Spring
5
,
4.
Clevis Pin 10 x 50mm
3
5.
10,3mm
(13/32")
flat
washer
Install the two upper support brackets through the back
plate and to the chassis, install the clevis pin 10x17mm
and secure with retainer spring.
Assemble
both support brackets to the outside of the
baggger support tube install the clevis pin 10x50mm and
secure with retainer spring.
1. 3/8 Lock nut
2.
FlatWasher
3. Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
1.
2.
3.
Hook
Discharge Chute
Back plate slot
3
Replace discharge chute into rear opening
of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
22

Publicidad

loading