Publicidad
Idiomas disponibles
Idiomas disponibles
Ersatzteile / Kundenservice
Carry out the settings using the following table
Factory setting: H4
WATER HARDNESS
ºdH
ºfH
0~5
0~9
6~11
10~20
12~17
21~30
18-22
31-40
23~34
41~60
35~45
61~98
1° dH = 1.25° Clark = 1.78 °fH = 0.178 mmol/l
° dH: German hardness ° Clark: British hardness ° fH: French hardness
17.2 Filling/topping up regenerating salt
Add regenerating salt before using the appliance for the first time. Observe the following
when filling the salt container:
Only use regenerating salts specially made for dishwashers.
The manufacturer will decline all liability for damage caused by the use of
unsuitable salts and the warranty will be voided.
Fill in regenerating salt before putting into operation.
When using multitabs with regenerating salt, it is not necessary to
add regenerating salt.
Do not pour in regenerating salt if the water hardness in the
residential area is 0-5° dH.
1. Remove the lower basket and unscrew the lid of the salt container.
2. When using for the first time, fill the salt container with approximately 1 litre of
water.
3. Position the funnel and pour in approx. 1.5 kg of regenerating salt. It is normal
that a certain amount of water runs out of the container as the salt is added.
4. Absorb spilt regenerating salt immediately with a damp cloth.
5. Fit the cover correctly and screw it on as far as it will go.
6. Start a washing programme immediately after filling.
7. Normally, the low-salt indicator switches off after running a washing programme.
Fill up with regenerating salt when the "low-salt indicator"
Page | 36
ºClark
ºmmol/l
0~6
0~0.94
7~14
1.0~2.0
15~21
2.1~3.0
22-28
3.1~4.0
29~42
4.1~6.0
43~69
6.2~8
Display
H1
H2
H3
H4
H5
H6
lights up.
Publicidad
