Dalbach GS60V-45-01 Manual De Instrucciones página 45

Frost protection measures
If the appliance is located in a place where temperatures are close to or below freezing,
observe the following:
 Remove the mains plug from the plug socket or switch off the fuse.
 Turn off the water tap and unscrew the supply hose.
 Allow the water to drain from the supply hose and inlet valve. (Place a vessel
under the hose to collect the water.)
 Connect the inlet hose to the inlet valve again.
 Remove the filter from the tray in the bottom of the dishwasher and draw the
water out of the rubber ring using a sponge.
20 7 Decommissioning the appliance
Observe the sequence of the work steps:
1. Pull out the mains plug or switch off the fuse for the plug socket.
2. Turn off the water tap.
3. Loosen the inlet and outlet hose.
4. Loosen fixing screws from the worktop, if present.
5. Remove the base board, if present.
6. Pull out the appliance, carefully pulling out the hoses at the same time.
7. Allow remaining water to drain from the hose
If the sink is 1000 mm or more from the floor, the remaining water cannot run out
directly into the sink.
In this case, collect the remaining water from the hose in a suitable vessel outside the
sink.
Transport
 Empty the appliance and secure loose parts.
 Transport the appliance only upright (so that no remaining water can run into the
machine controller and cause programme errors).
21 Faults
Before you contact after-sales service
FAULT
Appliance is not
working.
Dishes are not dry
or not properly dry
POSSIBLE CAUSE
Fuse blown or fused circuit-
breaker tripped.
Plug is not plugged in to the
plug socket.
Low water pressure
Appliance door does not close
properly.
No rinsing agent used or
dosage set too low
The detergent used has a poor
drying performance
Selected programme has no
"Dry" function
The "Extra dry" function was
Garantiebedingungen
REMEDY
Check fuses.
Plug the mains plug into the
plug socket.
Check whether the water supply
hose is correctly connected and
the tap is properly turned on.
Close the appliance door.
1. Fill with rinsing agent
2. Regulate rinsing agent
quantity
Use rinsing agent or combined
detergent with higher drying
capacity
Select programme with "Dry"
Activate the "Extra dry"
Page | 45