Publicidad
Idiomas disponibles
Idiomas disponibles
Ersatzteile / Kundenservice
FAULT
Plastic tableware is
not properly dry
Cutlery is not dry
Interior sides of the
appliance are wet
after the wash cycle
Dishes are not
properly clean
Detergent residues
in the appliance
Water stains on
plastic parts
Difficult to remove
white coatings on
dishes, inside the
appliance or on the
door
Page | 46
POSSIBLE CAUSE
not activated.
Water collects in recesses in
the crockery or cutlery
Drying process was not yet
finished
Normal phenomenon. Poorer
drying performance for plastic.
Cutlery incorrectly sorted
Normal phenomenon
• Dishes not properly arranged
• Rotation of the spray arms is
blocked
Clogged spray arm nozzles
Dirty filters
Incorrectly inserted filters
Wrong washing programme
The left and right upper
crockery baskets are not
adjusted to the same height
Tabs have not dissolved in the
short programme
Detergent is lumpy due to long
storage time
Drop formation cannot be
avoided
Deposits of detergent
ingredients
Water hardness range is
incorrectly set
Detergent with multiple
functions or
biological/ecological detergent
used
REMEDY
function, if available
Put away dishes at an angle if
possible
(see chapter 4.5 "Loading dishes
and cutlery"
Wait until the programme ends.
Open the door a little after the
end of the programme. Steam
can escape and the dishes dry
out.
No remedy possible (see chapter
Fehler! Verweisquelle konnte
nicht gefunden werden.
"Loading dishes and cutlery")
Load cutlery correctly
No action necessary
Load dish basket and cutlery
baskets without the spray arms
hitting them (see chapter
Fehler! Verweisquelle konnte
nicht gefunden werden.
"Loading dishes and cutlery").
Clean spray arms (see chapter 6
"Cleaning and maintenance")
Clean filter (see chapter 6
"Cleaning and maintenance")
Insert filters correctly
Select a more powerful washing
programme
Adjust the left and right
crockery basket to the same
height.
Set a more powerful programme
or use powder detergent
Use new detergent product
• Topping up rinsing agent
• Increase water softening
system setting
• Change detergent product
• Clean appliance mechanically
• Adjust water softening system
to higher water hardness
• Refill with regenerating salt
• Change detergent product
• Use separate agents
(dishwasher detergent,
regenerating salt, rinsing
agent)
Publicidad
