Publicidad
Idiomas disponibles
Idiomas disponibles
EN
➢ In order not to impair the function of the appliance, never cover or block
the ventilation openings/slots of the appliance cover.
➢ To ensure adequate ventilation, it is important that the clearance
between the wall and the front edge of the appliance is not less than 60
cm.
➢ Do not install refrigerator/freezer combinations with only one
temperature regulator in refrigerated rooms below 16 °C.
For more information on installation, see the installation instructions supplied.
11 Putting into operation
Clean the appliance and the interior parts thoroughly before putting into operation
(see chapter 4 "Service and maintenance").
•
Set the temperature according to the ambient temperature at the installation
location if the equipment is changed or if the appliance door is opened and closed
frequently.
•
With very high summer temperatures, set the temperature regulator to a higher
level to maintain the desired cooling temperature.
•
For optimum energy consumption, leave the glass shelves/drawers in the
appliance as shown (see Fig. Lebensmittel richtig lagern).
•
The freezer compartment is ready for use after about 3 hours.
11.1 Switching the appliance ON/OFF
1. Connect the appliance to the mains power supply.
→ When the appliance door is opened, the interior light comes on.
2. To switch on the appliance, press and hold "Adjust" (B1) for 5 seconds.
3. To switch off the appliance, press and hold "Adjust" (B1) for 5 seconds.
APPLIANCE DAMAGE!
Do not switch on the appliance immediately after a power interruption. Possible overload
of the compressor or fuse blows.
Setting the temperature
Connect the appliance to the mains power
supply. When the appliance door is
opened, the interior light comes on. The
temperature regulator is located on the
right-hand side of the interior.
1. Press and hold the "Adjust" (B1) button for 5 seconds to switch on the appliance.
2. When switching on for the first time, turn the temperature regulator to the
highest (coldest) setting.
The appliance reaches its normal working temperature after approx. 1 hour and is then
ready for operation.
3. Turn the temperature regulator back to a medium setting.
Page | 42
Publicidad
