Publicidad
Idiomas disponibles
Idiomas disponibles
Special care must be taken for fragile materials.
Follow the position indications marked on the packaging.
Special care must be taken during loading, unloading, transport, so as to avoid shocks.
Make sure that the packaging has not been damaged during these operations.
No damaged packaging shall be repaired by the customer.
CAUTION!
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions
are the direct consequence of its exposure in sequence to two or more factors or parameters, among which are
particularly critical:
thermal shock, which may result from exposing the product to high temperature conditions immediately after
exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water jets,
snow, immersion, etc.) immediately after exposure to high temperature conditions;
the formation of ice, which may result from exposing the product to below-freezing temperatures immedi-
ately before or after exposure to moisture, rain or water due to causes other than rain.
CAUTION!
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-
operative condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions
permitted (see paragraph 3.6) so as to avoid damage to the electrical/electronic part as a result of thermal shock,
ice formation or humidity, etc., which may deteriorate or damage these circuits.
NOTE: any conditions other than the above may be indicated in the component-specific and accompany-
ing documentation. In this case, the instructions in the specific documentation must be followed.
3.10. Command, control and safety devices
•
ON/OFF switch (5): switches the tool on and off.
•
LED (12) ON/OFF: indicates that the tool is operational.
•
Safety catch (8) active: it is inserted automatically by releasing the operating lever and prevents unintentional
start-up of the tool.
•
Bar cover (3): protects the cutting bar during transport.
•
Built-in protective device: protects in the event of motor overheating.
•
Built-in protective device: protects in the event of maximum current draw.
3.11. Symbols and warnings
General warnings
Reading the Use and Maintenance
Manual is mandatory
Obligation to wear eye protectors,
goggles and head protection
Do not use the tool in rain,
thunderstorms, adverse weather
conditions or on wet branches
Page 42
Adequate clothing is mandatory
Hand protection is mandatory
Obligation to wear safety shoes for
foot protection
Prohibition to use the tool in the
presence of overhead power lines,
maintain a safety distance of 15 m
from things, animals and/or persons
not involved/object of the activity.
0310.0360 Use and Maintenance Manual - Translation
of Original Instructions - Rev: 00, Date 07/02/2024
Publicidad
