Instrumental Measurements; Preparing For Use; Mounting The Base Unit - Motor Unit - Oregon 410-120 Manual Original De Instrucciones

410-120

Instrumental Measurements

A Measure the gauge
depth using the
suitable shape

Preparing for Use

ATTENTION Do not install the machine at eye level You are recommended to install it at a height of no more
than 3 9 to 4 2 feet (1 2 – 1 3 m) from the floor The machine can be bench-mounted or wall-mounted

Mounting the Base Unit - Motor Unit

Securing the Upper Housing / Motor Unit
Insert the bolt (I) in the dedicated slot (7) in the motor unit (A) and through the mounting hole (12) in the
support unit (B) Insert the washer (J) at the front and tighten the locking knob (H)
NOTE: you may need to depress the upper housing to ensure correct alignment
B Measure the
cutter length
C Measure the
chain pitch
Preparing for Use
13