Oregon 410-120 Manual Original De Instrucciones página 32

Troubleshooting
Troubleshooting
Turn the machine off by turning the switch to position "0" and unplug the power cable from the mains before you
start to work on the machine
Problem
The machine fails to start
when you switch on
(switch in position "I")
The lamp fails to switch
on when the switch is
turned to position "I"
The wheel is broken
or damaged
The machine vibrates
abnormally
STOP USING IMMEDIATELY
Contact a Skilled Technician if you are still unable to restore the correct operation of the machine following the
instructions given in the chart
32
Probable Cause
One of the safety devices of the
system to which the machine
is connected has tripped
(fuse, circuit breaker, etc )
The machine is not plugged
into the mains properly
The lamp has blown
The grinder is not
secured correctly
The motor unit is not secured
correctly to the base unit
The vise assembly is not secured
correctly to the base unit
The grinding wheel is not fitted
correctly in its seat on the hub
Solution
Reset the safety device
If the safety switch trips again,
do not use the machine, and
contact a Skilled Technician
Unplug and plug in again properly
Replace the lamp
Replace wheel
Check its attachment and,
if necessary, tighten the
securing screws correctly
Tighten the related locking
handle correctly
Tighten the related vise
adjustment knob correctly
Dismantle the grinding
wheel, check its integrity
and fit again correctly
410-120