Publicidad
Idiomas disponibles
Idiomas disponibles
410-120
Grinding Wheel Dressing
Wear personal protection equipment
Start the grinder by turning the switch to position "I"
Profile the grinding wheel (K) with the dressing brick
(O), always working with extreme caution, holding it
with two hands firmly and effectively
WARNING Contact with the grinding wheel
while it spins at high speed may cause burning
and abrasions
Setting the Sharpening Angles
WARNING
– Wear personal protective equipment when sharpening
– All adjustments must be made with the motor switched off and the grinding wheel completely stopped
– In the case of accidental impact or collision of the grinding wheel during the sharpening process, follow
the instructions given in the "CHOOSING AND INSTALLING THE GRINDING WHEEL – WARNINGS" section
– Clean the chain before sharpening it
– To avoid overloading the motor excessively and to avoid damaging the chain cutters, grind minimum
quantities of material and do not stop along the same cutter as this could burn the cutting edge
– Do not use cooling liquids during the sharpening process
WARNING Grinding creates sparks which could ignite flammable materials Do not
operate grinder in presence of flammable materials or explosive atmospheres
Setting the Sharpening Angles
Stop the grinder by turning the switch to
position "O"
Check if the grinding wheel (K) profile is
correct using the template (L) Continue to dress
wheel until profile matches template
17
Publicidad
