Oregon 410-120 Manual Original De Instrucciones página 24

Placing the Chain in the Vise
Placing the Chain in the Vise
– Clean the chain before sharpening it
– Check the cutters and find the one with the most damage, you will want to start with this cutter
– Ensure chain is placed in vise as shown, cutter direction heading toward right
Setting the Chain Stop
Put the chain in the vise (14)
Slide a chain cutter up against the chain stop (10)
Turn the adjustment knob (9) to position the chain
stop (10) laterally to the center of the cutter
24
Positioning the Cutter
Move the grinding wheel onto the cutter to be
sharpened by pulling the motor unit (A) downwards
using handle (E)
Turn the cutter adjustment knob (8) to move the
chain so that the cutter cutting edge skims the
grinding wheel (K) The chain should run freely
over the vise (14) throughout this procedure but
without any clearance
410-120