Oregon 410-120 Manual Original De Instrucciones página 18

Setting the Sharpening Angles
For Right-Hand Cutters without a Down Angle (0°)
Once you have established the type of chain to be sharpened, look up the adjustment angles
(vise, down and head tilt angles) in the "Grinding Angles Chart" on page 12 (columns A/B/C)
NOTE: if your chain has a down angle in column B on the "Grinding Angles Chart,"
please see the "For Right-Hand Cutters with a Down Angle" section on page 19
Setting the Vise Rotate Angle
Loosen the vise adjustment knob (16)
Turn the vise clockwise
Position the reference mark pointer (17) on the vise
by the desired vise rotate angle
Tighten the vise adjustment knob (16)
18
Right-Hand Cutters
Setting the Head Tilt Angle
Loosen the arm locking knob (H) at the back of
the motor unit (A)
Rotate the entire motor unit (A) until the reference
mark on the edge of the arm is positioned at the
desired head tilt angle (11)
Tighten the locking knob (H) at the back of
motor unit (A)
410-120