Publicidad
Idiomas disponibles
Idiomas disponibles
410-120
General Information
The manufacturer is not liable for damages in
the following cases:
– Failed observance of the instructions given herein;
– Use of the machine other than that described
in the "INTENDED USE" section;
– Failure to use in compliance with current standards
on Health and Safety at the workplace;
– Incorrect installation;
– Lack of scheduled maintenance;
– Modifications or jobs that are not authorized by
the manufacturer;
– Use of non–original or inadequate spare parts;
– Repairs that are not carried out by a specialist
Using and Keeping the
Operator's Manual
The characteristics and the information given in this
manual are merely indicative The manufacturer
reserves the right to add any modifications to the
grinder considered necessary at any time It is
forbidden to reproduce any part of this document
without authorization on behalf of the manufacturer
The operator's manual is an integral part of the
machine and must be kept in a safe place so that it
can be consulted whenever need be If you should
lose your manual or it should deteriorate, you can
request your dealer or an authorized service center
for another copy The manual shall accompany the
machine at all times
Safety Devices
The grinder is equipped with the safety devices
illustrated on page 10
– Shield guards: they protect the operator from parts
of the grinding wheel that may come away during
the sharpening process These guards must always
be fitted in place when the machine is in use
Always make sure the guards are efficient and fitted
properly Operator safety could be compromised
if the guards are damaged and/or cracked
– Switch: the machine features a safety switch with
release coil In the case of a sudden power failure,
the switch trips automatically and disconnects the
machine from the mains The machine will not start
even if the power supply is suddenly restored You
need to restart the grinder by turning the on-off
switch to the on position,"I"
Intended Use
This machine is an electrical grinder for saw chains
used on chain saws
– Use the machine exclusively for the types of
chains stated in the technical data chart
– Do not use the machine to cut or grind anything
other than the chains envisaged
– Secure the machine firmly to the bench or wall
– The machine must not be used in corrosive or
explosive environments
– Any other use is to be considered improper The
manufacturer is not liable for damages following
improper or incorrect use of the machine
Technical Data
Model
Voltage
Rated power
Grinding wheel
dimensions
Maximum speed of
grinding wheel
Maximum power
of lamp
Acoustic pressure level
Level of vibrations on
operating handle
Types of chains that
can be sharpened
Weight
(complete machine)
(*) only with specific kit (vise+grinding wheel)
to be ordered separately
Safety Information
410-120
120V~ 60Hz
220W
Outside Ø :
5 3/4" (145 mm)
Inside Ø:
7/8" (22 2 mm)
Thickness:
1/8" (3 2 mm)
3/16" (4 7 mm)
1/4" (6 3 mm)
3150 min
-1
0,5W
77 dB(A)
< 2,5 m/s
2
1/4"
325"
3/8"
404"
3/4" (*)
13 9 lbs/ 6 3 kg
9
Publicidad
