Oregon 410-120 Manual Original De Instrucciones página 16

Preparing for Use
Reinstall Flange
Using the 5 mm Allen wrench (N), insert the flange
(4) and tighten the screw (3)
Make sure you fit the flange as illustrated If the
grinding wheel is fitted with the flange too tight, it
could break during use and put the operator at risk
To avoid such risk, tighten screw (3) to 62 in-lbs
(7 Nm) If possible, check with a torque wrench
Reinstall Wheel Guard
Reinstall wheel guard (G) with guard securing screw
(F) in holes (6) using screwdriver (not included)
16
Checking the Assembly of the Grinding Wheel
Stand at the side of the grinding wheel
Start the grinder by turning the switch to position "I"
Once started, the lamp lights up to illuminate the
sharpening area
Visually make sure the grinding wheel does not
oscillate sideways or crosswise, consequently causing
abnormal vibrations
If this should be the case, stop the machine
immediately and check if the grinding wheel has been
fitted correctly If necessary, replace the grinding wheel
with another original one
Always check a freshly fitted grinding wheel at
working speed for at least one minute before you
start grinding, standing at a safe distance to the side
of the grinder, making sure no one else approaches
the machine
Checking the Grinding Wheel Shape
With the machine turned off, check the grinding
wheel (K) profile using the measuring template (L);
if necessary, dress the wheel to restore the
correct profile
410-120