Stopping And Shutting Down; Maintenance And Cleaning; Demolition And Disposal - Oregon 410-120 Manual Original De Instrucciones

Stopping, Maintenance, Disposal

Stopping and Shutting Down

Stopping
Turn the machine off by turning the switch to position
"0" and unplug the power cable from the mains

Maintenance and Cleaning

WARNING Grinder must be turned off and
the power cable unplugged from the mains
before any maintenance is performed
Inspect the power cord regularly for damage
Remove the plug from the mains immediately if
the cable is damaged or cut
When the grinding wheel reaches a minimum
diameter of approximately 105 mm, replace the
grinding wheel

Demolition and Disposal

The machine is to be demolished by qualified
personnel in compliance with current laws enforced
in the country in which it is installed The symbol (on
the rating nameplate) points out that the product
must not be disposed of with normal household
garbage Contact an authorized shop or your dealer
for disposal instructions
Before you scrap the machine, make sure it is
unusable For example, by cutting the power supply
cord Also make the parts safe, which could be a
source of danger for children if they play with
the machine
30
Shutting Down
Once you have finished using the machine,
disconnect it and clean it thoroughly
Store it in a dry, safe place, protected against
dust and dampness
After 40 hours of use:
– Clean the lamp carefully using a rag or a
cleaning brush Do not use compressed air
– Clean the grinder carefully using a rag or a cleaning
brush Clean the electric motor and the sliding
guides with caution Do not use compressed air
410-120