WARNINGS ON INTERFERENCE RISKS DURING USE IN DIAGNOSTIC
INVESTIGATIONS
This device is designed to meet the current requirements for electromagnetic compatibility.
As far as EMC requirements are concerned, electromedical devices require special care
when being installed and used, and are therefore required to be installed and/or used
in accordance with the manufacturer's specifications. Risk of potential electromagnetic
interference with other devices. Mobile or portable RF radio and telecommunication
devices (mobile phones or wireless connections) may interfere with the operation of
electromedical devices. The device may be susceptible to electromagnetic interference in
the presence of other devices used for specific diagnosis or treatment. For more information
visit www.flaemnuova.it.
TROUBLESHOOTING
Problem
The device switches on but
does not nebulise or does
it poorly.
The blue LEDs flash and the
appliance switches off after
few seconds.
The appliance switches off.
Light button (1A) turns red
and flashes and the appli-
ance does not nebulise or
switches off.
Cause
Remedy
• Immerse the medicine tray and
• Malfunction of the
medicine tray and
mesh unit.
• Ensure the small hole in the centre
• The medicine does
not flow into the
nebulising area.
• The inhalation treatment time de-
• The nebulising
speed depends
on the type of
• Angle: it must be kept upright when
medicine used.
• Gently dry the mesh with a cotton
• Liquid has seeped
out from the mesh
• No liquid in the
tray.
• Check for liquid in the medicine tray
• Five minutes have
elapsed from
• Switch the appliance on again.
switch-on.
• Replace the batteries (6) if alkaline.
• Batteries are down
• Recharge the Batteries if recharge-
or depleted.
23
mesh unit (2) in a solution of water
(50%) and white wine vinegar, rinse
and reassemble as described in
section 6.3 SANITISATION.
of the medicine tray cover (2B) is
not obstructed, if so, clean it.
pends on the type of medicine and
on the patient's inhaling capacity.
in use. If it is tilted backward, the
medicine does not touch the mesh.
swab or shake to remove any drop-
lets from the medicine outlet area.
(2).
able Ni-MH or Lithium.