Filling The Water Tank; Switching On For The FI Rst Time - melitta CAFFEO SOLO & milk Manual De Instrucciones

4.4

Filling the water tank

• Flip up the lid of the water tank (Fig. A, no. 7) and pull the water tank up
and out of the appliance.
• Fill the water tank to the maximum mark with fresh tap water and
reinsert it.
Note
If the water tank runs empty during operation (e.g. during the coffee dispensing
process), the symbol for the water tank will be illuminated. The current
operation will be stopped and the water tank must be fi lled before starting a
new operation.
4.5 Switching on for the fi rst time
Caution!
The appliance may only be vented without the Melitta
with a full water tank.
– Insert the Melitta
up for the fi rst time.
– Fill the water tank with fresh tap water to the max. mark before switching
the appliance on.
• Press the ON / OFF button
→ The symbol (symbol of valve)
needs to be vented to free all water lines from air.
• Place a large vessel under the steam pipe.
• Turn the valve switch (Fig. A, no. 11) clockwise to the stop to open the
valve.
→ The valve symbol
steam pipe.
• When water is no longer dispensed and the symbol for the valve
illuminated, turn the valve switch anti-clockwise to the stop to close the
valve.
→ The appliance is ready for operation.
52
Claris water fi lter into the water tank only after starting
® ®
to switch the appliance on.
will be illuminated on display. The system
fl ashes. Water will fl ow into the vessel under the
Claris water fi lter and
® ®
is