Publicidad
Idiomas disponibles
Idiomas disponibles
DETAIL DEVICE DESCRIPTION
14
INTELECT® TRANSPORT 2 SET COMPONENTS
The components of the Intelect
below.
COMBO SET INCLUDES:
47544
INTELECT TRANSPORT 2 COMBO
47979
User Manual
2
47383
5 cm
Ultrasound Applicator
48100
International Accessory Kit
- 40-0097
Leadwire Assembly, Ch 1
- 40-0098
Leadwire Assembly, Ch 2
- 79967
Silicon/Carbon Electrode 6x8cm Black
- 79970
Sponge Pocket 9x10.5 cm
- 12-10648
Nylatex Wrap 2-1/2x24 Sewn
- 42197
Dura-Stick+ 5cm Round Electrodes
ULTRASOUND SET INCLUDES:
47242
Intelect Transport 2 Ultrasound
47979
User Manual
2
47383
5 cm
Ultrasound Applicator
HEAD TO CART FIXATION
The optional Therapy System Cart, is designed for use with
the Intelect® Transport 2 device and allows the user to easily
transport the system from patient to patient within the clinic
as well as store all necessary accessories, supplies, and
applicators used for the various modalities of the System.
The fixation of the head to the cart is magnetic.
Remove the Intelect® Transport 2 device and cart from the
shipping carton. Visually inspect for damage. Report any
damage to the carrier immediately.
To assemble the Transport 2 Head to the Cart, follow these
steps:
1.
Insert the device onto the top of the cart by sliding the
front bottom of the device into the plastic lip on the top
front of the cart.
2.
Release device back gently on the cart. Magnets will help
to position the device correctly on the cart top.
47979 INTELECT TRANSPORT 2 COMBO (4778) AND ULTRASOUND (4776) USER MANUAL
Transport 2 set are shown
®
INSTALLING THE BATTERY PACK
The Intelect Transport 2 devices accommodate both AC mains
power and an optional Li-ion battery pack. To install the battery
pack in a Intelect Transport 2 device, do the following:
1.
Locate the battery access door at the bottom of the unit and
loosen the screws with a coin or a flat head screw driver.
2.
Remove the battery access door and retain it.
3.
Connect the battery pack cable to the unit's battery
connector in the bottom of the battery recess. Put the
battery pack into the unit.
4.
Replace the battery access door and re-tighten the screws
using the coin or the screwdriver.
5.
Reverse the steps in this section in order to remove the
battery pack.
EN
Publicidad
