KNF Yamato RE212-G Manual De Instrucciones página 108

4. OPERATION PROCEDURES
User Setting
List of user setting items

Press and hold the
Control knob
turning the
Control knob

Holding down the Control knob
without key operation for about two minutes, will discard the changes, and the display returns to
previous screen.

It is not possible to enter user setting mode during operation.
Setting Item
Rotation mode setting
(rot)
Auto inversion time setting
(SEC)
Auto-resume function
(Pon)
LED brightness setting
(dsp)
for two seconds. User setting items will be shown. Select an item by
. Press the
Control knob
for two seconds while the user setting item is displayed or leaving unit
Rotation mode can be selected.
F.ro: Forward rotation mode
r.ro: Reverse rotation mode
Ato: Timed auto inversion mode
Auto inversion mode repeatedly changes rotation direction
between forward and reverse, in accordance with time setting
"SEC".
Default setting is "F.ro"
Time interval for auto inversion mode can be set.
Setting range: 5-999 sec
Default setting is "5"
Select operation for the time power is restored from outage.
OFF: Unit goes into idle at power recovery.
ON: Unit automatically reverts to status just before power loss
and begin operation once again from that point.
Default setting is "OFF"
Change the LED brightness of the control panel.
The brightness can be set in 8 levels
Setting range: 0-7
Default setting is "3"
22
again to edit the displayed item.
Description
DE
EN
FR
Page
ES
P.23
IT
P.24
P.25
P.26