Publicidad
Idiomas disponibles
Idiomas disponibles
4. OPERATION PROCEDURES
Auto-resume Function
Select recovery mode for the event of a power failure.
OFF: Unit goes into idle at power recovery.
ON: Unit automatically reverts to status just before power loss and begin operation once again from
that point.
Default setting is "OFF"
1. Enter user setting
Fwd
Press 2 sec
2. Change the Auto-resume setting
Fwd
①
Fwd
③
3. Exit user setting
Fwd
R ev
AutoR
Sync
②
①
Rev
AutoR
Sync
②
①
Rev
AutoR
Sync
④
③
Rev
AutoR
Sync
Press 2 sec
① Press the Power key.
② Press the
Control knob
rpm is on the screen.
Unit enters user setting.
① Turn the
Control knob
RPM display: "Pon" flashes
② Press the
Control knob
RPM display: Current setting flashes
③ Turn the
Control knob
④ Press the
Control knob
After completing the setting, press the
two seconds. Display reverts to previous screen and
shows current rpm.
25
for two seconds while current
and select "Pon".
.
to select ON/OFF.
to finalize.
Control knob
for
Publicidad
