Descargar Imprimir esta página

QJMOTOR SRK 550 RS Manual Del Usuario página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

optional positions. Just move the
clutch handle horizontally forward
slightly, and then rotate the ring
nut adjuster to align with the arrow
to adjust the required position. The clutch handle
A
in position 1 is the farthest from the grip, and the
clutch handle in position 4 is the closest to the grip.
Right handle (option 1)
① Start/stop switch/electric start button
Turn the switch to "
"
position: The motorcycle
circuit is turned on, and the
engine can be started.
Turn the switch to "
"
position: The motorcycle circuit is turned off, and
the engine cannot be started.
Make sure that the engine start/stop switch is turned
to the "
" position, retract the side stand, shift the
transmission to the neutral position, press the
electric start button "
", and the electric motor runs
to start the engine.
Front
If the engine does not start within 5 seconds, turn
the ignition switch to the "
10 seconds, wait for the battery voltage to recover,
and then start the engine again. If it still fails to
start after several attempts, please contact the
local QJMOTOR dealer service station to check
the motorcycle.
Do not turn the switch from "
normal driving, as this may damage the engine or
exhaust system. Do not use the stop switch unless
in an emergency.
② Hazard warning light button
Press the hazard warning light button, and the front
and rear turn signal lamps flash at the same time to
remind you of hazard.
③ Throttle control grip
The throttle control grip is used to control the engine
speed. To accelerate, turn the handle in its own
17
Warning
" (off) position, wait for
Warning
" to "
" during

Publicidad

loading

Este manual también es adecuado para:

Qj500gs-7a