Publicidad
Idiomas disponibles
Idiomas disponibles
2. Measure the free travel of the throttle control grip
at its flange. The standard free travel should be 10°
to 15°.
The motorcycle is equipped with the throttle cable of
double-wire structure, the throttle cable
throttle line, and the throttle cable
return line. Please follow the steps below to adjust
the free travel of the throttle grip:
(1) Remove the throttle cable dust boot
(2) Loosen the lock nut ③
(3) Fully screw in the adjusting
nut ④
(4) Loosen locknut ①
(5) Turn the adjusting nut ② so
that the free stroke of the throttle control handle is
10° ~ 15°.
(6) Tighten locknut ①
(7) Adjust the nut ④ to make the throttle handle
rotate flexibly.
(8) Tighten the lock nut ③
Adjustment of clutch
The free travel
of
shall be 10 ~
20mm
the clutch starts
is the
A
to loosen, subject to the end position of the clutch
is the throttle
B
handle. If any abnormality is found, adjust the
handle end of the clutch cable as follows:
(1) Remove the clutch cable dust
boot.
(2) Loosen the lock nut ①.
(3) Screw in or out the adjusting
screw ② to make the free travel of
the clutch meet the specified
requirements.
(4) Tighten the lock nut ①.
If the handle end of the clutch cable cannot meet the
requirements of the free stroke after being adjusted
to the limit position, it can be adjusted by the lock nut
35
the
clutch
before
Publicidad
