wattage ratings may cause overload of the circuit
system and premature damage to the light source.
Notice
When replacing the light source, the same specifi-
cation as the original vehicle must be used. The
high-power light source will increase the load of
the circuit system, which will easily cause battery
power loss and other faults.
Headlamp beam adjustment
The headlight beam can be adjust-
ed up and down in the vertical direc-
tion. The beam height adjustment
screw ① and ② is located on the
back of the headlight. Turn the
height adjusting screw ① clockwise to lower the left
low beam and high beam simultaneously; turn the
height adjusting screw ① counterclockwise to raise
the left low beam and high beam simultaneously;
turn the height adjusting screw ② clockwise to lower
the right low beam and high beam simultaneously;
turn the height adjusting screw ② counterclockwise
to raise the right low beam and high beam simulta-
neously.
Notice
When adjusting the beam height, the driver should
sit on the seat cushion of the motorcycle, with both
tires on the ground, and keep the motorcycle in a
vertical state for adjustment.
ABS use and maintenance instructions
When the power lock is turned on, the ABS indicator
on the instrument panel will be on (not flashing),
which is normal. When the riding speed reaches
5km/H, the ABS indicator on the instrument panel
will go out, and the ABS is in normal working condi-
tion.
ABS lamp is on (not flashing), indicating that ABS is
in the diagnosis state.
If the ABS lamp is off, it indicates that the ABS is in
normal operation.
Flashing of ABS lamp indicates that ABS is not
working (or faulty).
48