Key Automation ALT3KF Instrucciones Y Advertencias Para Su Instalación Y Uso página 49

9
1
10
5
11
12
13
14
15
16
17
18
19
Pre-flashing duration time if FLASH out used as Flash
tP.r.
Light
Clearance. Allows to stop before the fully open position: it
is useful to avoid mechanical stress during opening
Hold-to-run (Hold command to execute)
de.a.
0 = off
This parameter determines the behavior of the red and
green lights of the barrier
5 = MODE1
• Red light on if closed
• If open, all the LEDs are off
• Flashing green light during opening
• Flashing red light during closure
• Barrier stopped but not on the limit switches flashing
IN.D.
red light
6 = MODE2
• Red light on if closed
• If open, steady green light
• Flashing green light during opening
• Flashing red light during closure
• Barrier stopped but not on the limit switches flashing
red light
se.r.
Service interval cycle threshold (0 = off)
Enabling of continuous flashing indicating service
required with
se.f.
closed)
0 = off
1 = on
Set to 0 if the old CTLIGHT2 module is used.
Electric lock activation time (in seconds), if FLASH
EL.T.
SETUP=3
Magnetic lock deactivation time if FLASH SETUP=4
High-speed motor start-up
ST.P.
0 = off
1 = on
1 = Off (use of virtual encoder)
En.C.
2 = On (use of motor's physical encoder)
2= Restore of factory settings for sliding gate
motor SU700M
3= Restore of factory settings for sliding gate
DE.F.
motor SU1100M
4= Restore of factory settings for 4/6 mt barriers
5= Restore of factory settings for 8 mt barriers
≠ 0 (only active with barrier
0 0 20 s
0 0 30 %
s
0 0 900
6 5 6
x
10 0 200 1000
cycles
0 0 1
1 0 1
4 1 10 s
0 0 1
1 1 1
2 2 5
EN
49