down the engine to run within the normal operating
range.
Driving on a slope
When climbing a steep slope, the motorcycle will
begin to slow down and appear to be underpowered.
At this time, the vehicle should be switched to a low
gear so that the engine can resume its normal power
output. The gear should be shifted quickly to prevent
the vehicle from losing power for a short time.
When going downhill, the vehicle should be
switched to low gear to facilitate braking. Be careful
not to rev the engine too high.
Use of brake and stop
To fully close the throttle, release the throttle control
grip while applying the front and rear brakes evenly
and downshifting to reduce speed.
Before the motorcycle stops, hold the clutch handle
(disconnected position) tightly and change to the
neutral position. Observe the neutral indicator in
order to identify neutral.
Warning
The braking system is an important safety component.
Contact your local QJMOTOR Service Organization
service
station
for
replacement. Improper maintenance of the brake
system can adversely affect braking performance and
may result in death or serious injury.
Warning
Please use the front and rear brakes evenly.
Preferring to use either the front or rear brake will
accelerate
brake
wear
performance. Driving with excessively worn brakes
can result in brake failure, which can cause death or
31
brake
system
repair
and
reduce
braking
or