QJMOTOR SRT 550 Manual Del Usuario página 54

engine.
● Coolant
Coolant Type: Soft
water and glycol-based
engine specific
antifreeze coolant
compatible with
aluminum radiators.
Use the original antifreeze coolant. Use of other
coolant/mixtures that do not meet the requirements
will cause damage to the engine.
When the new vehicle leaves the factory, the coolant
has been installed, and attention should be paid to
the inspection of the coolant level in the expansion
pot during maintenance.
When the coolant becomes turbid or reaches the
maintenance
QJMOTOR service station to replace the coolant in
time.
When the engine is turned off and cooled, check the
coolant in the expansion pot. During the inspection,
make sure that the motorcycle is on the horizontal
plane and the motorcycle body is vertical. Remove
MAX
the small guard in the middle of the left side of the
MIN
vehicle, observe the coolant volume in the
expansion pot, and make sure that the coolant
volume remains between the MIN and MAX marks.
If the coolant level is below the MIN mark, remove
the expansion pot cap plug and add coolant, or add
coolant at QJMOTOR service.
Warning
Do not add the coolant until the engine is turned off
and cooled. To avoid burns, do not open the coolant
filler cap until the engine has cooled down. The
48
cycle, please go to the local