Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
This machine is a pressure unit as can be seen in the CE declaration of conformity and Data
plate. The equipment supplied conforms to the Essential Safety Requirements according to
Annex I of Directive 2014/68/UE (PED). Any work involving repairs, modifications, and/or
changing pressurized components or parts make safe use of the equipment very risky. Any
tasks done must be authorized by the Manufacturer.
This manual contains important information pertinent to operator safety.
Read this manual through before beginning operation of the machine.
The manufacturer reserves the right to modify this manual and the machine
itself with no prior notice. We therefore recommend checking any updates. This manual must
accompany the machine in case of sale or other transfer.
Any repair, modification, or changing of components not formally agreed with and authorized by
the manufacturer poses a risk of the conformity to Directive 2014/68/UE being nullified and
makes this pressure equipment a significant risk. If not authorized in writing the Manufacturer
considers the tasks indicated above to be tampering with the machine, which nullifies the initial
declaration of conformity issued, and so they do not accept any direct responsibility.
Braze welding of parts that contribute to the pressure strength of the equipment and the parts
directed attached to it was done by adequately qualified personnel, using adequate operating
methods. Approval of the operating methods and personnel was entrusted to a competent
outside party for category III pressure equipment, and any work on this equipment that involves
the need to carry out braze welding must comply with the requirements laid down in annex 1 of
Directive 2014/68/UE, or the Manufacturer must be contacted for the relevant information.
− The pressure equipment has been inspected and tested, complete with the safety
accessories identified by the manufacturer as being of a direct discharge type with
calibrated air pressure. Testing and inspection of the accessories is not necessary prior
to starting up.
− The pressure equipment must be subjected to routine inspections and checks when
operating, according to the relevant regulations and legal norms.
For the unit in question, it is hereby declared that a competent Authorized Body carried out their
part of the final check according to annex I of point 3.2.3 of Directive 2014/68/UE as well as
checking safety accessories and control devices in conformity to comma d) of art 5 of Ministerial
Decree 329 of 01/12/2004.
List of the critical components in terms of PED safety DIR 2014/68/UE
Condenser, dehydrator filters, distributor, refrigerant storage bottle, airtight compressor, safety
pressure switch, pressure transducers, and safety valves.
The operator has to check/substitute the PED critical components before their respective end of
life (according to national law)
CARE OF THE MANUAL
This manual must be kept for the entire life of the machine and protected against humidity and
excessive heat. Take care not to damage this manual in any way during consultation.
INSTRUCTIONS MANUAL
-4-
Publicidad
