M.J. MALLIS GROUP SIAT S2-S Manual De Instrucciones Y Recambios página 90

13-MAINTENANCE AND REPAIR
13.6 SUGGESTED PRODUCTS FOR LUBRICATION
GREASE TYPE:
METAL/METAL: B.C.190 HEAVY DUTY (otherwise grease for chains and
bearings)
METAL/PLASTIC: PLATE MASTER M+L (molybdenum grease and PTFE
for plastic and metallic materials)
OIL TYPE:
regular lubricating oil or general purpose spray lubricant.
13.7 LUBRICATION OF THE TAPING UNIT
Lubricate monthly with oil the points shown on Picture.
A spring holder pin
B spring tension pin
C roller shaft
D cutter hinge
E blade guard pin
13.8 BLADE CLEANING
Skill 2 operator
Lift the blade guard and clean the blade by using a brush (with a long
handle) and some oil. The oil prevents the adhesive clotting.
13.9 BLADE REPLACEMENT
Skill 2 operator
- Lift the blade guard as shown in Picture
- Release the screws.
- Remove the blade.
WARNING!
Very sharp blade.
Any error may lead to bad injuries.
- Insert the new blade paying attention to the position of its sharp side.
- Fix the screws.
- Release the guard..
ENGLISH
Sharp side
90 January 2007