Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.
Preparing for use
UNIT LOCATION
Use the unit in properly ventilated, open spaces. Do not block the air inlet and
exhaust outlet of the device. Keep the unit away from any hot surfaces. Always
operate the unit on a level, stable, clean, fireproof surface and out of the reach of
children and persons of impaired mental, sensory and intellectual functions. The
work area of the unit should provide immediate access to the ignition switch.
ASSEMBLY OF THE UNIT
The product is delivered almost ready for operation, it only requires refilling the
engine oil and fuel in the tank, as it is deprived of them during transport for safety
reasons. The use of the product depends solely on the user's needs and
applications. In some models equipped with an additional electric starter the use
of an external battery is needed to be able to start them with the it. In this case
please use the fixed battery terminal cables with connectors (+ red, - black) to
connect the battery with the engine.
3.3.
Device use
3.3.1 Before starting up for the first time
•
Place the engine on a flat, solid, fireproof surface, not tilting more than
20
o
from the proper vertical.
Fill up with engine oil, as the engine is deprived of it during transport. To
•
do this, unscrew the oil plug and fill up with engine oil through it until the
level reaches the correct level on the plug's dipstick (only one plug can
have a control dipstick) - preferably close to the maximum permissible
level. The oil level should be checked by screwing in/inserting the plug
with the dry dipstick into the engine and after a few seconds unscrewing
it again and checking the oil level on the dipstick.
IMPORTANT: Do not overfill the engine oil - it can damage the engine! In
case of overfilling the oil above the permissible level, its excess can be
sucked out through the opening from the filler plug. Always check the
engine oil level with the engine off and cold or cooled down.
EN
Publicidad
