Utility Programmes - Corghi EM 9580 Manual De Uso

- Perform a spin.
- at the end of the spin, select the balancing
programme icon
knob or the ENTER button until the required
programme is selected.
The displayed image now shows only one po-
sition search.
- Apply the balancing weight in the 12 o'clock
position on either the outer or inner side, or
at the centre of the rim well, indifferently. If
applied in the well, the weight is applied on
a diameter smaller than the rated diameter of
the rim. A value of 2 or 3 inches less than the
rated value must therefore be entered when
the diameter is set in order to obtain correct
results.
Best results can be achieved if the weight is
divided into two parts to be applied on the two
sides of the rim.

UTILITY PROGRAMMES

The Utility programmes are all the functions of
the machine that are useful for its operation but
are not strictly connected to its normal operation.
Select the Utility and configuration programmes
icon to display the list (menu) of the utility pro-
grammes .
Working environment program
This wheel balancer allows three operators to
work at the same time thanks to three different
working environments.
- Select the Working environments icon to call
up a different working environment.
- The following icons are displayed:
the lit icon shows the operator selected.
- Press the Kis knob or the ENTER button to
select the icon desired.
EM 9580 - Operator's manual
and press the Kis
- Press the Exit button
setting and exit.
- The selection can also be seen in the working
screen status line.
By selecting a new operator, the machine resets
the parameters that were active at the last recall.
The stored parameters are:
- Balancing mode; dynamic, ALU, motorcycle,
etc.
- Wheel dimensions: distance, diameter and
width or those relating to the active ALU pro-
gramme.
- OPT: last OPT.
The machine's general settings remain the same
for all working environments: grams/ounces,
sensitivity x5/x1, threshold, etc...
FLASH OPT
Optimisation Programme
This procedure reduces the possible vibrations
still present in running vehicles after an accu-
rate balancing. Based on our experiences, the
programme can be recalled every time it is con-
venient to minimise the running noise produced
by the vibrations mentioned above.
The machine also indicates whether or not it is
necessary to carry out the procedure by display-
ing the following icon
The calculations performed by this programme
are based on the unbalance values measured
during the last spin performed which must there-
fore refer to the wheel being serviced.
Proceed as follows to recall this programme:
- Select the OPT Flash icon
OPT STEP 1
1. Take the valve to 12 o'clock.
2. Press the Kis knob or
operation.
OPT STEP 2
3. Turn the wheel until the valve gets to 6 o'clock
position (the bottom arrow turns from red to
green).
to save the
in the status bar.
.
ENTER to confirm the
73
UK