Selection Of Adhesive Weights Application Position - Corghi EM 9580 Manual De Uso

displayed as follows:
- Select the utility and configuration pro-
grammes icon
Select the configuration programmes icon
-
.
Automatic Position Search
(RPA) Configuration
Enables/disables the automatic positioning of
the wheel at the end of the spin. After the list of
the setting programmes is displayed, proceed
as follows:
- Select the Automatic position search con-
figuration icon
The following icons are displayed:
RPA OFF; disables the automatic position search
procedure.
RPA ON; enables the automatic position search
procedure.
- Press the the Kis knob or
select the icon desired.
- Press the
setting and exit.
The selection can also be seen in the working
screen status line.
Selection of adhesive weights
application position
To access this programme you must:
- select the Utility programmes icon,
- select the configuration programmes icon
- Three icons will appear on the display that
represent the possible positions, as shown
below:
78
.
.
ENTER button to
Exit button to save the
H12: the balancing weight must always be applied
in the 12 o'clock position regardless of the type
of balancing programme selected or the type
of weight to be applied (adhesive or spring);
LASER: the balancing adhesive weight must be
applied in correspondence of the laser line
(in all balancing programmes) whereas the
clip weight must always be applied in the 12
o'clock position;
CLIP: the balancing adhesive weight must be ap-
plied using the weight holder in ALU1 and ALU2
programmes, whereas the spring weight must
always be applied in the 12 o'clock position.
- Use the Kis knob or the arrow buttons to se-
lect the desired position. The selected icon is
enabled if it is in the following configuration:
- Press the Exit button to save the setting and
exit .
The selected configuration is displayed on the
status bar in the working environment.
Unbalance rounding-off
configuration
Sets the unbalance rounding-off to grams x1 or
grams x5, or, if set to ounces, to oz x 1/4 or oz x 1/10,
with which the unbalance values are displayed.
Select the unbalance rounding-off
-
icon.
- The following icons are displayed:
Set grams x1; displays the unbalance values
gram by gram.
Set grams x 5; displays the unbalance values
5 grams by 5 grams.
If the unit of measurement is ounces:
Set tenths of an ounce; displays the unbalance
EM 9580 - Operator's manual