Corghi EM 9580 Manual De Uso página 80

Language configuration
The language of the messages displayed on the
monitor can be selected.
After the list of the setting programmes is dis-
played:
Select the language setting
-
- A list of flags is displayed. Select the flag
corresponding to the desired language by
pressing the Kis knob or
- Press the Exit button to save the setting and
exit .
This programme can be exited only by select-
ing a language, then the unbalance image is
displayed again.
Lighting LED activation/
deactivation
It is possible to activate or deactivate the LED
light when present on the machine.
After the list of the setting programmes is dis-
played:
- Select the lighting LED activation/deactivation
icon
- Three icons will appear on the display that
represent the possible light modes, as shown
below:
LED1. In this configuration, the light turns on
when:
- at the end of a spin cycle if residual un-
balances are present for 30 seconds;
- in CP (centred position) for an additional
30 seconds.
LED2. In this configuration, the light turns on
in the conditions indicated for the LED1
programme and, in addition, also in the
following conditions:
- when the internal sensor is extracted. When
the sensor returns to the rest position, the
light turns off;
- during the entire measurement cycle with
all balancing programmes;
80
icon.
the ENTER button .
- during the Hidden Weight programme
when selecting the two planes behind the
spokes.
LEDOFF: deactivated
Press the Kis knob or the ENTER button to select
the desired mode. The selected icon is enabled
if it is in the following configuration:
- press to confirm the selection made
and exit the function.
LASER activation/deactivation
It is possible to activate or deactivate the laser
when present on the machine.
After the list of the setting programmes is dis-
played:
- Select the LASER activation/deactivation icon
- Two icons will appear on the display that rep-
resent the possible LASER modes, as shown
below:
LASER OFF.
LASER ON. In this configuration, the laser
turns on in the following cases:
for the manual application of all adhesive
weights.
IMPORTANT:
If the operator selected the adhesive weight
application configuration using a CLIP, in the
Alu1 or Alu2 balancing programmes the laser will
not be activated as the weight will be applied
using the weight holder
In the Hidden Weight programme, the selection
of the two new positions behind the spokes is
done in the 6 o'clock position using the laser
line.
Press the Kis knob or the ENTER button to select
the desired mode
The selected icon is enabled if it is in the following
configuration:
EM 9580 - Operator's manual