Corghi EM 9580 Manual De Uso página 76

the Weight Management, it is necessary to select
the icon Statistics.
The displayed screen shows:
• The counter of all spins performed dur-
ing the entire working life of the machine
.
• The counter of the weight quantity (spring and
adhesive) saved during the entire working life
of the machine
• The counter of the spins performed since the
last machine reset
• The counter of the weight quantity saved since
the last machine reset
• A histogram showing a comparison between
the spring weight quantity required if the Less
Weight programme is not used (red rectangle),
and the quantity required if the Less Weight
programme is used (green rectangle), in relation
to the entire working life of the machine.
• A histogram showing a comparison between the
adhesive weight quantity required if the Less
Weight programme is not used (red rectangle),
and the quantity required if the Less Weight
programme is used (green rectangle), in relation
to the entire working life of the machine.
Note: the values shown by the counters are
updated with each spin in relation to the Less
Weight programme selected.
The Reset icon allows you to zero-set the partial
counters.
76
.
.
.
Visual inspection function
This function allows the wheel to be run at low
speed and with the guard open, This allows visual
checking for any geometrical irregularities in the
rim and wheel.
Follow the description detailed below to start
the procedure:
- keep the button
guard open for as long as necessary for wheel
inspection.
When the button is released, the wheel-holder
shaft locking device activates automatically.
Highest accuracy function
This function allows the operator to check the
balancing results on the screen with the best
possible accuracy ("Gr x1" or "Oz 1/10").
- Select the highest accuracy icon
Keep thethe Kis knob or Enter
-
pressed as long as desired.
EM 9580 - Operator's manual
pressed with the
.
button