Default Test Preferences - EXFO FTB-8510B Guia Del Usuario

System Tab

Default Test Preferences

Default Test Preferences
Press System and Preferences.
Allows setting the default test parameters that will be applied every time a
test is created manually using Test Setup or when using SmartMode (not
supported on the FTB-8140). Changes to the default test preferences will
only apply when a new test case is created.
Note: The default test preferences are saved per slot on the FTB-500 meaning that
the configuration will not follow the module when changing the module
from one slot to another. However, a configuration on a specific slot will
remain when replacing a module by another module of the same model.
Configuration
Laser On: Selects Laser On every time a test is created manually using
the wizard or when using SmartMode. The Laser On check box is
selected by default.
STS-1 Fixed Stuff Columns
Enable Bulk Filled Override fills up the bytes of the STS-1 SPE's
columns 30 and 59 with the selected pattern from the tab Pattern TX on
page 405 when the Enable Bulk Filled Override check box is
selected. The Enable Bulk Filled Override check box is selected by
default.
530
FTB-8100 Series Transport Blazer