Copy Default Settings - Kyocera Ai3010 Manual De Instrucciones

Copy default settings

The following 16 types of settings can be changed in the copy default setting mode.
Set them as desired, in order to gain full use of your copier.
Copy default setting
1 Exposure mode
2 Exposure step
3 Auto exposure
4 Mix size den.
5 Txt ori density
6 Pho ori density
7 Orig quality
8 Paper selection
9 Default drawer
0 AMS mode
! Copy limit
@ Margin width
# Border Erase w
$ Erase size
% Insert tray
^ Rotate sort
109
Selects the auto exposure mode (page 36) or the manual exposure mode (page 35) for the
copy exposure mode when power is turned on.
Changes the number of exposure steps in the manual exposure mode.
Changes the overall exposure when using the auto exposure mode.
Adjusts the exposure of the original when selecting photo & text mode in the copy quality
selection (page 36).
Adjusts the exposure of the original when text mode is selected in the copy quality selection
(page 36).
Adjusts the exposure of the original when photo mode is selected in the copy quality selection
(page 36).
Selects the default setting in the copy quality selection (page 36).
Specifies whether the drawer with paper of the same size as the original is automatically
selected or whether paper size is selected manually.
Specifies the paper feed drawer to be selected automatically when warm-up ends or when the
Reset key is pressed. Paper feed drawer 3, 4 and multi-bypass can be selected only when the
optional paper feed desk and multi-bypass is installed.
Sets whether to enlarge/reduce the image of the original (see AMS mode on page 41) or copy it
to the same size when an original has been set and the Paper Select key pressed.
Limits the number of copies that can be made at a time.
Sets the initial value of the margin width for the left or upper margin in the margin copy mode
(page 50).
Sets the initial value of the border erase width for the sheet erase or book erase in the border
erase mode (page 55).
Sets the size of the original used in "custom size" of the border erase mode (page 56). Borders
outside the defined area will be erased.
Sets the drawer containing the insert sheets used in the insert mode (page 65). Paper feed
drawer 3, 4 or multi-bypass can be selected only when the optional paper feed desk and multi-
bypass is installed.
Sets whether the normal sort copy (page 90) or rotate sort copy (page 91) is used when the
sort mode is selected.
* This setting is not displayed when the copier is equipped with the optional finisher.
Content of copy default setting Page
113
114
114
114
114
115
115
115
115
116
116
116
116
117
117
117