Kyocera Ai3010 Manual De Instrucciones página 29

‚ */Language key
(Press to set copy management, default settings and language
selection.)
ΠProgram key
(Press to copy according to programmed settings. See page 92.)
„ Staple key (Indicator)
(Press to staple copies finished with the optional finisher. The
indicator is lit while the staple mode is ON. See page 130.)
´ Sort key/Sort indicator/Group indicator
(Press to sort copies into separate sets, or for sorting or grouping
copies with optional finisher. The indicator will light in either mode.)
Initial mode (at the end of warm-up or when the Reset key is
pressed)
In the initial mode, paper of the same size as the original is selected
automatically ("auto paper selection mode"), the number of copies is
set to "1", "manual exposure mode" is set for the copy exposure mode
and copy quality is set to "Text & Photo" mode.
* It is also possible to change the copy exposure mode from "manual
exposure mode" to "auto exposure mode" in the initial mode.
(See "1 Exposure mode" on page 113.)
Auto clear function
About 90 seconds after copying stops, the copier will automatically
return to the same settings as those after warm up. (However, the
exposure mode will not change.) Copying can be performed at the
same settings (copy mode, number of copies and exposure mode) if
copying is started before the auto clear function kicks in.
Automatic drawer switching function
If two drawers contain the same size of paper and the paper in one
drawer runs out during copying, this function switches paper feed from
the empty drawer to the full drawer.
* The automatic drawer switching function can be disabled.
(See "1 Auto drawer SW" on page 122.)
24