Machine Default Settings - Kyocera Ai3010 Manual De Instrucciones

Machine default settings

The following 8 types of settings can be changed in the machine default setting mode.
Set them as desired, in order to gain full use of your copier.
Machine default setting
1 Auto drawer SW
2 Auto shut-off
3 Special paper
4 APS
5 Auto preheat
6 Auto shut-off
7 Display contrast adj.
8 Management code
change
9 Silent mode
Content of machine default setting
Selects whether the automatic drawer switching function (page 24) is used or not.
Turns the auto shut-off function (page 96) On or Off. The auto shut-off function automatically
turns off main switch if copying is not performed for a certain period of time.
* If auto shut-off interferes with your copying operations, turn this function off. It is
recommended to prolong the time interval that triggers auto shut-off before turning actually it
off.
In case of selecting the paper size on the message display, displays (*) next to the paper size
of the drawer if it contains special paper such as colored paper or recycled paper. Drawer 3 or
4 can be selected only when the optional paper feed desk has been installed.
Selects whether paper in the drawer set for the "3 Special paper" on page 123 is used or not
in the auto paper selection mode or automatic drawer switching (page 24).
Selects a certain length of time from when copying ends to when the energy saver function
(page 95) is actuated.
Selects a certain length of time from when the copier is not used to when the auto shut-off
function (page 96) switches off the power automatically. The auto shut off function can be
turned off as well. This setting cannot be used in that case ("2 Auto shut-off").
The initial setting is 60 minutes.
* It is recommended to prolong time interval that triggers the auto shut-off if the copier is used
frequently, whereas shorten it if it is not used frequently.
* See "2 Auto shut-off" to release the auto shut-off function.
Changes the display contrast when the message display is not seen clearly.
Changes the pin code that accesses the management mode (page 97) and management mode
in this default setting (page 108).
* If pin code is changed, keep a note of the new one. If you forget it, enter the pin code "6482".
The copier can be switched to the silent mode, which stops the motor inside the copy machine
immediately after copying has been finished. When "On" is selected, the motor stops
immediately after copying has been finished.
Page
122
123
123
123
124
124
124
124
125
118