Connection Code; Run Start-Up Guide; Alarm Log - Grundfos CRE Instrucciones De Instalación Y Operación

7.36 "Connection code"

Pump variant
CME
CRE, CRIE, CRNE, CRKE, SPKE,
MTRE
This menu is only available in Grundfos GO.
You can set a connection code to avoid having to press the
connection button each time and to restrict remote access to the
product.
Setting the code in the product using Grundfos GO
1. Connect Grundfos GO to the product.
2. In the product dashboard, select "Settings".
3. Choose "Connection code".
4. Enter the wanted code and press [OK].
The code must be a character string (ASCII).
You can always change the code. The old code is not needed.
Setting the code in Grundfos GO
You can define a default connection code in Grundfos GO so that
it automatically attempts to connect to the selected product via
this code.
When you select a product with the same connection code in
Grundfos GO, Grundfos GO automatically connects to the
product and you do not have to press the connection button on
the module.
Define the default code in Grundfos GO in this way:
1. In the main menu, under "General", select "Settings".
2. Choose "Remote".
3. Enter the connection code in the field "Preset connection
code". The field now says "Connection code set".
You can always change the default connection code by pressing
[Delete] and entering a new one.
If Grundfos GO fails to connect and ask you to press the
connection button on the product, it means that the product has
no connection code or has a different connection code. In this
case, you can only establish connection via the connection
button.
After setting a connection code, switch off the product
until the light in Grundfos Eye turns off before you
can use the new connection code.
56

7.37 "Run start-up guide"

"Connection code"
●
●
This menu is only available in the advanced control panel.
The startup guide automatically starts when you start the pump
for the first time.
You can always run the startup guide later via this menu.
The startup guide guides you through the general settings of the
pump.
•
•
•
•
•
•
* This function applies only for pumps fitted with advanced

7.38 "Alarm log"

This menu contains a list of logged alarms from the product. The
log shows the name of the alarm, when the alarm occurred and
when it was reset.
Pump variant
CME
CRE, CRIE, CRNE, CRKE, SPKE, MTRE
"Language". See section 7.26 "
"Select date format".*
See section 7.27 "Date and time" ("Set date and
"Set date".*
See section 7.27 "Date and time" ("Set date and
"Select time format".*
See section 7.27 "Date and time" ("Set date and
"Set time".*
See section 7.27 "Date and time" ("Set date and
"Setting of pump"
– "Go to Home"
– "Run with Constant curve"/"Run with Constant pressure".
See section 7.4 "Control mode".
– "Go to "Assisted pump setup".
See section 7.41 "Assisted pump
– "Return to factory settings".
functional module, FM 300. For further information, see
section 5.2.1 Identification of functional
"Run start-up
guide"
●
●
Language"
.
time").
time").
time").
time").
setup".
module.