SICE S 1000 Manual De Instrucciones página 164

- Press the button (1, Fig. 50f) to take a sensor reading (Fig. 50e).
- Once the value is read, the data entry screen appears as shown in Fig. 50f, with the sensor
data automatically compiled.
In some cases, the sensor conveys data only if tyre pressure changes by at least 0.2. For
these sensors, the message DEFLATE WHEEL will appear on the display, so a pressure
change is required to enable valve transmission.
If the reading is not acquired, the message "Valve
not recognised" is shown on the display (Fig.
50g). Check that the sensor is positioned correctly
and press to repeat the procedure (1, Fig.
50g). If the problem persists, check if the sensor
is damaged.
Replace the sensor if damaged, following the in-
structions in the section relative to sensor date
(2, Fig. 50h).
- At the end of the procedure, press the
button (1, Fig. 50h) to exit the programme, then
repeat the procedure to test sensor function.
- Press the button to exit the TPMS function
and e return to the main screen.
NOTE: At the next activation of the TPMS device the screen in Fig. 50f will be displayed
with the data of the previous vehicle. Press button 3, Fig. 50f to select a new vehicle or
button 1, Fig. 50f for a new sensor reading.
TROUBLESHOOTING
The TPMS does not respond
Sensor connector disconnected
- Connect the connector (see Fig. 50i)
The sensor assembled on the valve is broken
- Check TPMS operation with another sensor
faulty TPMS
- If the problem persists, contact the technical
assistance.
164
CAUTION!
1
2
1
User manual S 1000
50g
50h
50i