Setting Motor Torque During Position Recovery; Setting Opening Speed (And Closing For Bg30/1600 - Bg30/2200); Setting Closing Speed (High Speed And Reversible Motors Only); Setting End Of Manoeuvre Constant Approach Speed - Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador

Setting motor torque during position recovery

Adjust motor torque with parameter
insu cient to allow the gate to complete the manoeuvre.
If position recovery is not completed, normal gate operation will not be resumed.
The response of the obstacle detection system depends solely on the values set for parameters
The response of the obstacle detection system depends on the values set for parameters
maximum current value stored during travel acquisition.
The response of the obstacle detection system is a 70% reduction in maximum torque for a period of 1 s.
The response of the obstacle detection system is a 80% reduction in maximum torque for a period of 2 s.
The response of the obstacle detection system is a 100% reduction in maximum torque for a period of 3 s.
The response of the obstacle detection system is a 100% reduction in maximum torque for a period of 5 s.
Setting opening and closing speed
N.B.: the speed setting range for the speci c motor installed is automatically subdivided into 10 equal segments.
See chapters 14 and 15
01= 6 m/min ... 10= maximum speed.

Setting end of manoeuvre constant approach speed

Once deceleration is complete, the gate continues to the limit switch at constant speed. The distance is set with
the parameters and .
01= 2 m/min; 02= 2,5 m/min; 03= 3 m/min; 04= 3,5 m/min; 05= 4 m/min.

Setting number of automatic closure attempts after activation of sensing

edge or obstacle detection (crush protection)

No automatic closure attempts.
From 1 to 3 automatic closure attempts.
We recommend setting a value equal to or lower than the value set for parameter
Automatic closure is only performed if the gate is completely open.

Setting photocell mode during gate opening (FT1)

DISABLED. Photocell is not active or not installed.
STOP. The gate stops and remains stationary until the next command is received.
IMMEDIATE REVERSE. The gate reverses immediately if the photocell is activated during gate opening.
TEMPORARY STOP. The gate stops as long as the photocell is obstructed. The gate resumed opening when the
photocell is cleared.
DELAYED REVERSE. The gate stops if the photocell is obstructed. The gate closes when the photocell is cleared.

Setting photocell mode during gate closing (FT1)

DISABLED. Photocell is not active or not installed.
STOP. The gate stops and remains stationary until the next command is received.
IMMEDIATE REVERSE. The gate reverses immediately if the photocell is activated during gate closure.
TEMPORARY STOP. The gate stops as long as the photocell is obstructed. The gate resumed closing when the
photocell is cleared.
DELAYED REVERSE. The gate stops if the photocell is obstructed. The gate opens when the photocell is cleared.

Photocell (FT1) mode with gate closed

This parameter is not visible if
If the photocell is obstructed, the gate cannot open.
The gate opens when an open command is received, even if the photocell is obstructed.
The photocell sends the gate open command when obstructed.
if, during position recovery, the values set with parameters
, or is set.
and are
and .
and and on the
.
71