Function Buttons And Display; Switching On Or Commissioning; Display Function Modes; Parameter Display Mode - Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador

8

Function buttons and display

UP
DOWN
PROG
• Press the UP and/or DOWN
• Use the + and - buttons to modify the value of the parameter. The value starts to ash.
• Press and hold the + or - button to scroll quickly through values, to modify the parameter more quickly.
• To save the new value, wait a few seconds or move onto another parameter with the UP
display ashes rapidly to indicate that the new value has been saved.
• Parameters can only be modi ed while the motor is not running. Parameters can be viewed at any time.
9

Switching on or commissioning

Power the control unit.
The rmware version of the control unit is displayed brie y.
Version installed r1.65.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 10.
10

Display function modes

10.1

Parameter display mode

PARAMETER
PARAMETER
See chapter 12 for detailed descriptions of the parameters.
TEST
buttons to view the parameter you intend to modify.
VALUE
BUTTON DESCRIPTION
UP Next parameter
Previous parameter
DOWN
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Travel acquisition
TEST Activate TEST mode
or DOWN button. The
61