General Safety Precautions - Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador

1

General safety precautions

WARNING: IMPORTANT SAFETY INSTRUCTIONS
THESE INSTRUCTIONS MUST BE FOLLOWED TO GUARANTEE THE
This installation manual is intended for quali ed personnel only.
Failure to observe the information included in this manual may result in
personal injury or damage to the equipment.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury
due to improper use or any use other than the intended usage indicated in
this manual.
The installation, electrical connections and adjustments must be performed
by quali ed personnel, in accordance with best practices and in compliance
with applicable regulations.
Read the instructions carefully before installing the product.
Incorrect installation may pose risks.
Before installing the product, make sure it is in perfect condition: In case
of doubts, do not use the product and refer exclusively to professionally
quali ed personnel.
Do not install the product in explosive environment and atmosphere:
in ammable gas or vapours constitute serious danger for safety.
Before installing the motor, make all structural modi cations related to the
safety precautions and to the protection or segregation of areas involving
crushing, shearing, dragging risks or any other risks.
WARNING: check that the existing structure ful ls the required resistance
and stability speci cations.
ROGER TECHNOLOGY is not liable for failure to observe the good practices
in the construction of xtures to be motorised or for deformations that may
occur during use.
The safety devices (photocells, sensing edges, emergency stops, etc.) must
be installed taking into consideration the following: the regulations and
directives in force, the good practices criteria, the installation environment,
the operating logic of the system and the forces generated by the motorised
door or gate.
The safety devices must protect any areas where there is crushing, shearing,
dragging or any other danger in general generated by the motorised door or
gate; the installer is advised to check that the moving wings do not have
sharp edges or anything that may pose shearing and/or dragging risks.
If it is deemed necessary based on the risk analysis, install sensing edges
on the mobile part.
It should be noted that, as provided by the UNI EN 12635 standard, all
52
SAFETY OF THE PERSONS
PRESERVE THESE INSTRUCTIONS