Sound Warnings; Performing Measurement; Measurement Function/ Sub-Function; Selecting Measurement Function/ Sub-Function - KPS Multicheck6010 Manual De Usuario

Multicheck6010

3.5 Sound warnings

Short high sound
Continued sound
Upwards sound
Short sound
Downwards sound
Periodic sound

3.6 Performing measurement

3.6.1 Measurement function/ sub-function

The following measurements can be selected with the function selector switch:
• Voltage/rotation/frequency measurement
• Earth resistance
• R Low
• R Insulation
• Line impedance
• Loop (Loop RCD) impedance
• RCD
The function/sub-function name is highlighted on the display by default.

3.6.2 Selecting measurement function/ sub-function

Using navigation keys ▲▼ select the parameter/limit value you want to edit. By using ◀▶ keys
the value for the selected parameter can be set.o.
Once the measurement parameters are set, the settings are retained until new changes are
made.

3.6.3 Performing tests

When symbol is displayed test can be started by pressing the "TEST" button. After completion
of the test its result value and status will be displayed. In case of PASSED measurement, result
value will be displayed in black color along with the
measurement, the result value will be marked in red color along with the

3.7 Setup menu

To enter the Setup menu, press the SETUP key. In the Setup menu, the following actions can be
taken:
• Isc factor:
• Date/Time:
• Start function:
• RCD standard:
• ELV:
• Power off time:
• Cont timeout:
• ISO timeout:
• Supply system:
• Device info:
button pressed
during continuity test when result is <35 Ohm
attention, dangerous voltage applied
power off, end of measurement
warnings (temperature, voltage at input, start not possible)
Warning! Phase voltage on the PE terminal! Stop all the measurements
immediately and eliminate the fault before proceeding with any activity!
Set prospective short/fault current scaling factor
Set internal date and time
Selected function will start when switched on
Select national standard for RCD testing, e.g EN61008 or BS7671
Select voltage for ELV warning.
Select time when device should switch off if not used.
Select time-out when measurement should stop automatically.
Select time-out when measurement should stop automatically.
Select supply network/system, e.g. TN or IT.
Shows info about device, e.g. Firmware version
status symbol. In case of NOT PASSED status symbol. In case of NOT PASSED
- 61 -
EN
symbol.