Continuity Test - KPS Multicheck6010 Manual De Usuario

Multicheck6010

4.2.2 Continuity test

How to perform low current continuity measurement
Step 1
Select the Continuity function with the FCT key and select the Cont mode with the
▲▼ and ◀▶navigation keys. The following menu will be displayed:
Step 2 Set the following limit value:
• Límit: limit resistance value using the ▲▼ and ◀▶ navigation keys.
Step 3
Connect test cable to the instrument and the item under test. Follow the connection
diagram shown in figure 4.9 to perform the Continuity measurement.
Step 4 Check the warnings and online voltage/terminal monitor on the display before starting
the measurement. If everything is OK and the
start the measurement. The actual measuring result with
applicable) will be displayed during the measurement.
As this is a continuous test, the function will require stopping. To stop the measurement
at any time press the TEST key again. The last measured result will be displayed at any time press the TEST key again. The last measured result will be displayed
together with the
Figure 4 8: Continuity measurement menu
Figure 4 9: Connection of universal test cable
or indication (if applicable).
- 66 -
is shown, press the TEST key to is shown, press the TEST key to
or indication (if
EN