Internal Lining; Fastening System; Storage; Accessories And Parts - SCHUBERTH SR 1 Manual De Instrucciones

H. CARE AND MAINTENANCE

3. INTERNAL LINING

The headband cushion, the cheek comfort pads and the ear pads
can be hand-washed using a mild detergent (best if well diluted
with water) at a maximum temperature of 30 °C. Allow damp
linings to dry at room temperature in airy conditions.

4. FASTENING SYSTEM

The double-D fastening system is maintenance-free.
Warning: Do not oil or grease the metal parts of the
double-D fastener.

5. STORAGE

Store the helmet in the pouch provided in a safe, dry place. To
avoid buildup of moisture inside and to prolong the life of the
anti-fog coating, ensure that the visor is not completely closed.
Ideally it should be set to the 2nd position above the urban mode
setting. Always place the helmet so that it cannot fall onto the
fl oor.
Note: Keep the helmet out of reach of children and animals.
86
I. ACCESSORIES AND PARTS

1. ACCESSORIES AND PARTS

For an overview of all available accessories and parts, visit
www.schuberth.com and go to 'Accessories' for your helmet
model.
Warning: All other helmet components may only be replaced
by your dealer for safety reasons.

2. COMMUNICATIONS SYSTEMS

Warning: Fitting any communications system (including
ordinary headsets) into a helmet constitutes a modifi cation to
the helmet. The communications system and headsets must
therefore be specially tested and approved for use in helmets
in accordance with the European helmets standard ECE-R
22.05. Otherwise, installation of such items will invalidate the
approval and insurance conformity of the helmet. Proof for
an ECE-R 22.05 approval of a helmet – in conjunction with
a suitable communications system – is only valid where it is
certifi ed by an offi cial approval authority of the EU member
states. Other forms of information from these institutions
(including the general suitability of communications systems
for use in motorcycle helmets) or information from other
institutions are of no relevance, and the helmet will lose its
approval if these are used.

3. OBTAINING ORIGINAL SCHUBERTH PARTS

You can obtain original SCHUBERTH parts through your dealer.
You can fi nd your specialist SCHUBERTH dealers on the SCHUBERTH
website www.schuberth.com under the 'Motorcycle' product
area and the 'Dealer' heading.
87