Ice Thickness Check - Pkm0335/Pkm0425/Pkm0535 - Motak PKU0155SA Manual De Instrucciones

Section 2

ICE THICKNESS CHECK - PKM0335/PKM0425/PKM0535

After a harvest cycle, inspect the ice cubes in the ice storage bin. The ice thickness float
switch is factory-set to maintain the ice bridge thickness at 1/8" (3 mm).
NOTE: Make sure the water curtain is in place when performing this check. It prevents
water from splashing out of the water trough.
1. Inspect the bridge connecting the cubes. It should be about 1/8" (3 mm) thick.
2. If adjustment is necessary make the following adjustment as you face the machine.
NOTE: The float can be adjusted with a 3/4" wrench while the water trough is in place.
• Turn the ice thickness float switch to the right to increase bridge thickness.
• Turn the ice thickness float switch to the left to decrease bridge thickness.
• Test run two cycles to verify bridge thickness.
Ice Thickness Float
Switch Adjustment
Part Number: 000016426 Rev 00 08/2020
Ice Machine Operation
25