Remedial Descaling Procedure; Exterior Cleaning; Ice Machine Inspection; Door Removal Pkm0335/Pkm0425/Pkm0535 - Motak PKU0155SA Manual De Instrucciones

Cleaning and Sanitation

REMEDIAL DESCALING PROCEDURE

• This procedure descales all components in the water flow path, and is used to descale
the ice machine between the bi-yearly descaling/sanitizing procedure without removing
the ice from the bin.
• This technology will also allow initiation and completion of a cycle, after which the ice
machine automatically starts ice making again.

EXTERIOR CLEANING

Clean the area around the ice machine as often as necessary to maintain cleanliness and
efficient operation.
Wipe surfaces with a damp cloth rinsed in water to remove dust and dirt from the outside
of the ice machine. If a greasy residue persists, use a damp cloth rinsed in a mild dish soap
and water solution. Wipe dry with a clean, soft cloth.
The exterior panels have a clear coating that is stain resistant and easy to clean. Products
containing abrasives will damage the coating and scratch the panels.
• Never use steel wool or abrasive pads for cleaning.
• Never use chlorinated, citrus-based or abrasive cleaners on exterior panels and plastic
trim pieces.

ICE MACHINE INSPECTION

Check all water fittings and lines for leaks. Also, make sure the refrigeration tubing is not
rubbing or vibrating against other tubing, panels, etc.
Do not put anything (boxes, etc.) in front of the ice machine. There must be adequate
airflow through and around the ice machine to maximize ice production and ensure long
component life.

Door Removal PKM0335/PKM0425/PKM0535

1. Use a Phillips screwdriver to loosen the two screws securing the door. Do not remove,
they are retained to prevent loss.
2. Tilt door forward and lift up to remove.
32 Part Number: 000016426 Rev 00 08/2020
Section 3