Parameter Descriptions - Level 3; Diagnostic Parameters - Leroy-Somer Digidrive SK Serie Guía De Usuario

Français
6.3

Parameter descriptions - Level 3

No Function
71
to
61 70
Pr to Pr set up
80
Set Pr 71 to Pr 80 to the required advanced parameter number to be accessed.
The value within these parameters will be displayed in Pr 61 to Pr 70. Pr 61 to Pr 70 can
then be adjusted to change the value within a parameter.
See Digidrive SK Advanced User Guide for further details.
6.4

Diagnostic parameters

The following read only (RO) parameters can be used as an aid to fault diagnosis on the
drive. See Figure 8-1 Diagnostics logic diagram on page 86.
No
81
Frequency reference selected
82
Pre-ramp reference
83
Post-ramp reference
84
DC bus voltage
85
Motor frequency
86
Motor voltage
87
Motor speed
88
Motor current
89
Motor active current
90
Digital I/O read word
91
Reference enabled indicator
92
Reverse selected indicator
93
Jog selected indicator
94
Analog input 1 level
95
Analog input 2 level
80
English Deutsch
Function
Italiano
Range
0 to Pr 21.50
Range
±Pr 02 Hz
±Pr 02 Hz
±Pr 02 Hz
0 to Drive maximum VDC
±Pr 02 Hz
0 to Drive rating V
±9999 rpm
+Drive maximum A
±Drive maximum A
0 to 95
OFF (0) or On (1)
OFF (0) or On (1)
OFF (0) or On (1)
0 to 100 %
0 to 100 %
Digidrive SK Getting Started Guide
Español
Defaults Type
RW
Type
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
Issue Number: a